Use the normal slide-out control switch to extend the room. NOTE: If wall switch is not pushed within 60 seconds of entering the electronic manual override mode, the controller will revert to normal operating mode. No action is required to return to normal operating mode. 8 SCHWINTEK IN-WALLâ„¢ TROUBLESHOOTING GUIDE.
Schwintek Slide Manual
Aug 21, 2015 Posted August 21, 2015. If you have 2 sets of gear rails down the sides of your slide, you have a Schwintek. These slides have 2 or 3 white plastic rollers underneath that will eventually cause wear, destroying the undercoating or even channeling into the the wood floor. Yous can see bits of the undercoating sticking to the rollers in the photos. View and Download Lippert Components Schwintek In-Wall troubleshooting and component replacement online. SLIDE-OUT system for caravans. Schwintek In-Wall automobile parts pdf manual download.
![Installation Installation](/uploads/1/1/8/9/118990397/695032396.jpg)
Schwintek Slide Manual Override
Well, made it to Florida for our spring break trip. Overnighted at a Cracker Barrel in Rock Hill, SC where we used the bedroom slide, then on to Fort Wilderness. Upon setting up, the bedroom slide worked well on the rear side, but would only move a few inches on the forward slide. After much troubleshooting and trying to remove the motor, I removed the entire track assembly (not a good idea on the road) and fished out the motor. Using a too short ladder, I got on the slide roof and got it from there.
Upon disection, I found the timing magnet split in half and loose on the shaft. I figure it had a winter cracking and the rough roads split it the rest of the way. The motor would turn, but the computer couldn't count the turns and would shut it down.
Road repair, super glue the halves back together and added a plastic washer to the top I cut out of some packaging in the pantry to hold it together. Works like a champ!
Sent from my SM-G900V using Tapatalk